Kitfox Aircraft Stick and Rudder Stein Air Grove Aircraft TCW Technologies Dynon Avionics AeroLED MGL Avionics Leading Edge Airfoils Desser EarthX Batteries Garmin G3X Touch

Conversation Between GWright6970 and VP-22

3 Visitor Messages

  1. Hello again. Bruce @ zensurfer55@gmail. Completed riveting internal stiffeners. Fitted ribs, etc. Half the ribs are marked 27001. The other half are not marked. Assuming they are the 27002's which are supposed to have thicker "webs." I can't see or measure a difference.
  2. Bruce, let's exchange email addresses so I can send you photos of my wings before covering, etc. Please send me your email address, to mine listed below. If I can't help you I am sure Lowell can figure this out!

    Cheers, Grover. Sky172plt@aol.com
  3. Hello: I am a new builder, Classic IV. When beginning to install the internal stiffeners on the wing tubes it occured to me that it would be difficult to pass the ribs over the rivots at a later date. Acc. to the manual, this is the correct order of steps and I know certain ribs must be notched for the antidrag brackets to be fit but what about the ribs in that section of the tubes? Thank you for your help. Bruce - In Eastern N.C.
Showing Visitor Messages 1 to 3 of 3