Kitfox Aircraft Stick and Rudder Stein Air Grove Aircraft TCW Technologies Dynon Avionics AeroLED MGL Avionics Leading Edge Airfoils Desser CPS Parts EarthX Batteries Kitplane Parts

Conversation Between HighWing and Iain Donnelly

5 Visitor Messages

  1. Ian,
    The dimensions look good for my mount, but the picture at Lockwood - not so good. My mount has the mounting brackets fitting within the top and bottom tabs as seen in the following link https://www.summitracing.com/parts/ear-21000erl I am not sure my mount will work.
    Lowell
  2. Hi Lowell,
    Sorry to be a nuisance but I’m not sure I’ve sent info properly, the dimensions are L 8.5” H 3.5” width 1 5/8” pitch of connection,s 7.125 and height 0.75” the part No with Lockwood aviation is 886-033.

    Thanks

    Iain Donnelly
    Ps the number G0504030 is stamped on the forward tail plane attachment point does it have any significance.
  3. I should have asked the size of the oil cooler. Distance between mounting holes side to side, front to back and top to bottom.
  4. Iain,
    I am sorry this has taken so long. I was in Florida visiting kids and grand-kids and though I saw the alert, I couldn't find your note using my cell phone. I would be happy to make a mount. It might take a couple of weeks as I have a lot of catching up to do. I will keep you posted and don't you hesitate contacting me if you have any questions.
    Lowell
  5. Dear Lowell,
    I have nearly completed my Kitfox iv 1200 Classic round cowl, Arplast VP prop,but not happy with my oil cooler bracket suspended from the left hand gearbox tapped holes, I have read about your design, could you supply me with a pair? I am based in Scotland UK
Showing Visitor Messages 1 to 5 of 5