Sabre
04-11-2019, 06:55 PM
I searched the forum but did not see anything related to what I'm seeing. The right flaperon's trailing edge seems to have a twist to it which results in the flaperon rocking in and out of the setup jig. The leading edge appears to be straight. Basically the outboard end of the trailing edge is touching the workbench and the inboard side is 13/32" off the workbench. The left flaperon's leading and trailing edge are basically flat on the workbench. The workbench is flat and level. The spec for drilling the rivet holes for the control horn has a resolution of 1/32" with no variance listed. Looking for input on how best to proceed with this. Thanks, Greg