Right control stick pivot

[Mesteve]

So, what is the truck to get right control pivot to “turn in” after opening up the hole?

[LetMeFly]

I’d like to bump this and add I’m having the same problem. I’m gonna need to practically trim out the reinforcement circle to get it in place! :eek:

[jiott]

Keep working with it, trying different angles while twisting. It will go in without much force.

[LetMeFly]

Thanks for the quick reply. I might have to do that; use force. I just took some pictures of it and you can see there's a long way to go before it will fit. I even ground down the flange to help it clear.
24449 24450 24451

[efwd]

That is a drag. I remember it being just as Jim says. I thought, WTH?, no way is thiii, oh, it dropped in. Granted, I did a little widdling as well before it fit.

[Kitfox Pilot]

Thanks for the quick reply. I might have to do that; use force. I just took some pictures of it and you can see there's a long way to go before it will fit. I even ground down the flange to help it clear.
24451

I just put that piece in and I had to grind from where your piece is now around the top of the hole then stick a screw driver in the hole of the part you are trying to get in an PRY pretty hard to pop it in. I think a bolt on wing would be a good improvement on that piece.
Be sure and get the paint out before you press the bearings in also.