PDA

View Full Version : Super-fill



Frontier Fox
10-18-2018, 04:22 PM
I have finally begun my build, getting in a few hours from time to time. I was wondering about Super Fill. How much is needed for the whole build.
I am using balsa on the horizontal stab. and elevator and was going to use Super-Fill to smooth and shape.
I see it is available from AS and thought I would order the amount for the whole build. So how much is typically needed?
Thanks
Joe G.

Esser
10-18-2018, 07:51 PM
One kit (I think it’s a quart total?) should be enough. I did what you are planning and had enough

Frontier Fox
10-18-2018, 08:37 PM
Ok, so will one kit be enough to do the lift strut fairings also?

Joe G.

Esser
10-18-2018, 08:42 PM
Yes, it was for me.

Frontier Fox
10-18-2018, 08:52 PM
Ok, thank you for the quick reply.

Joe G.

efwd
10-18-2018, 09:24 PM
I happened to run out. I used it to smooth the transition of the leading edge to spar as well as firewall forward fiberglass and the ends of the flapperons in addition to what you mentioned. I would just buy some now then if you need it buy some fresh stuff later. It could be a year or two later depending on your build speed.

rocketman2tm
10-19-2018, 12:16 PM
Personally, I would only buy one kit at a time to ensure it stays fresh. That's more so based on the speed that I build.

BTW, I don't think that it comes with the kit.

aviator79
10-19-2018, 12:17 PM
My kit did not come with Super Fil. I think the kit relies on mixing flox or micro with Hysol, which isn't a bad filler either. I'm on my second quart of Super Fil, and I'll barely have used much out of it when I'm finished. I still have the strut fairings to do. If you're careful about not over-mixing, then 1 quart will probably get you there. You may need a second, but I wouldn't order two up front. Wait until you need it.

efwd
10-19-2018, 03:34 PM
my original product did arrive in my Kit. I have only used about a fifth of my second jars.

jrevens
10-20-2018, 10:21 AM
None came in my kit either. I eventually ended up buying 2 also, but only used a small quantity of the second one. Like others have said, only buy one at a time. The epoxy tends to separate from the solids, and it needs to be stirred thoroughly.

Frontier Fox
10-20-2018, 10:36 AM
I did not get a Superfil kit with my SS7 kit so I will order one kit as recommended.



Thank you all for your advise.

Joe Gallagher

————————
Building SS7

jiott
10-20-2018, 11:23 AM
My kit came with Super-Fill but only because I ordered quite a few optional items, including Super-Fill, with my kit.

efwd
10-20-2018, 10:03 PM
yeh Jim, thats probably the same for me. I ordered nearly all the options.