aviator79
08-05-2018, 05:19 PM
Can anyone tell me if I'm missing something? I scoured the forums, and it looks like to curves on the lower edge of the boot cowl should fit over the lower fuse longerons and the firewall. My firewall extends well past the lower longerons though, so I can't fine a satisfactory position for it.
Also, If I make the aft end of the forward flange flush with the front of the firewall (per the manual), the bottom curves don't match the angle of the longerons. I think the thing to do here is to make the bottom edge fit right, as the rest of the cowl will me match-fit to the boot cowl flange, so some error here is permissible. Did anyone else notice this?
https://lh3.googleusercontent.com/_-o1ylLz0EBvxox8R8956I3BvwBWsKzVDeIhFJP2HtKDBE_Dr_SZ dDDD83BDRLfnFz1svafWj9niP6nbxfy-odIf8wtIdJ_IUnRceh71wF_s_DFVOgtblAWzXJKLqwYjNWizAb nBYz0=w600
Also, If I make the aft end of the forward flange flush with the front of the firewall (per the manual), the bottom curves don't match the angle of the longerons. I think the thing to do here is to make the bottom edge fit right, as the rest of the cowl will me match-fit to the boot cowl flange, so some error here is permissible. Did anyone else notice this?
https://lh3.googleusercontent.com/_-o1ylLz0EBvxox8R8956I3BvwBWsKzVDeIhFJP2HtKDBE_Dr_SZ dDDD83BDRLfnFz1svafWj9niP6nbxfy-odIf8wtIdJ_IUnRceh71wF_s_DFVOgtblAWzXJKLqwYjNWizAb nBYz0=w600