Kitfox 5 Rudder leading edge

[SilverFox5]

Hi
I thought I had read something about tips on how to cut the slot openings in the rudder trailing edge fairing but cannot seem to find it know.
I have the leading edge fit to ribs and am very happy on how that came out. But I am a little lost on the best way to layout the slot openings, I have a series 5 but it should be the same as the 6 & 7 or very close. Can I get some direction here?
Thanks, in advance!

Joe

[SilverFox5]

Hi
Sorry, I need to proof read before sending.
I am looking for tips on cutting the slots in the rudder LEADING edge, not trailing edge.

Joe

[jmodguy]

I used a dremel tool with a sanding drum. I quit when I could get enough room to get the bolt/nut on and tooling needed to tighten them.

[jiott]

I believe the SS7 manual has the cutout templates. I used their templates and they worked OK, but it was tight.