Top Photo

[SkySteve]

Does anyone have a photo of the cabin framework taken from above, looking down into the cabin of a model IV or newer? It's time for some additional mods and for one mod it would help to see this view.

[efwd]

Now I do. Hope its sufficient

[efwd]

Forgot. It is a SS7
Eddie

[Northof49]

Hi
Here is a photo of a Model IV, aft, looking forward. Will this help?

[SkySteve]

Yes! Thank you both. I know I'm asking for a lot here, but now my A&P wants any 3 or 4 of the measurements: Red, Yellow, Green, White. All 4 would be more than great. Any 3 will work. What I'm trying to accomplish is to update the cabin frame on a model I to the newer design which allows for greater headroom for 2 people. I can extrapolate the correct info for the model I with 3 or 4 of the measurements.

http://i237.photobucket.com/albums/ff12/KitfoxSteve/Kitfox%20frame%20measurements.jpg (http://s237.photobucket.com/user/KitfoxSteve/media/Kitfox%20frame%20measurements.jpg.html)

[efwd]

Not too much at all. I will get those for you tomorrow night.
Eddie

[SkySteve]

Thank you, Eddie.

[efwd]

Green 6 3/8"
White 9"
Yellow 11.5"
Red 33.5". Measured from where your arrows end. Not the entire width of that tube.

[TJay]

Hey Steve Not sure if your interested but this is what I did on my model 1 to make it a bit stronger, little bit less welding, drilled out the pin holders, slid a .035 tube inside then welded new pin holders back in, super easy to do, also changed that same over head tube your talking about,

[SkySteve]

Thanks, Eddie. Perfect!
TJay, great idea. I like it.