flaperon horn

[Flybyjim]

So I am setting up the assembly for the control horn. I have a question about the distance from the flaperon hinge and the control horn, The instructions show 4-3/4 inch from the center of the flaperon hinge to the flaperon horn but is the 4-3/4 to the center of the inboard horn flange or center of the horn arm? It looks like the flange but I'm not sure.

[efwd]

Not clear on what parts are what as I'm at work and not referencing the manual. I was confused and did this wrong. See the photo. I had measured to where the center of the rod end bearing would be. This is wrong. I had to weld these holes closed and pull the arm out further away from the flapperon. Hinge to closest edge of the arm. Embarrassed to show this but I got confused too. Hope that helps.
Eddie

[Flybyjim]

Thanks Eddie,

Just a few extra words in the instructions would be appreciated in critical parts. It would be so easy to just add 4-3/4 inch from center of inboard flange.