View Full Version : Help!!!! Flap rigging on a model 2 or 3
dalords
08-09-2016, 08:53 PM
Can anyone help me with how to set the flap travel on a model 2 or 3. Should the flap handle go all the way to the floor for the 0 position and how may inches off the floor with the flap handle would equal about 20 degrees on the flaperons?any info would be great.
rv9ralph
08-09-2016, 09:35 PM
Here is a picture of the flap handle on my KF3. Note that there are 3 detents for position. The total movement is not that much for the 3 settings. On the earlier Kitfoxes, the flap works more as a trim than traditional flaps.
11534
Ralph
Livermore, CA
dalords
08-10-2016, 04:21 AM
So Ralph how far or how many degrees do your flaperons when you put them on all the way?
dalords
08-10-2016, 06:32 AM
Ralph if you don't know the degrees of travel. how many inches up is the handle from the floor measured at the end of the yellow portion of your handle?
rv9ralph
08-10-2016, 09:00 PM
I didn't build my Kitfox, so I do not know the build set-up process, I do have the manuals, but a quick scan did not show the process.
Tomorrow, if I remember while at the hangar, I will measure the throw at the end of the handle for each of the 3 settings.
Ralph
rv9ralph
08-13-2016, 09:59 PM
Ok, I finally had a chance, and remembered to get some pictures for you. In the following pictures I placed my scale next to the flap lever to show the distance from the floorboards for each of the 3 positions. I then placed the scale next to the position notches so you could see the distances for those.
This is the most upper position
11540
The middle position
11541
The lower position
11542
The next 2 photos show the length of the flap arm and the detents on the selector stop plate. The Phillips screw head is a stop.
11543
11544
Ralph
Livermore, CA
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.