Water Pump Screws and Torque

[Tomfox]

I see that I have one SS screw with a copper washer, and I failed to note which hole it goes in. Which hole does it go in? I am looking at the housing from the rear of the engine, and I see a hole at 6 o-clock, 8 o-clock, 10 o-clock, 12 o-clock , and 3 o'clock. Which hole does it go in?

What torque should I use for these screws. I read that the torques on this engine are all specified and have tight tolerances.

Thanks
Tom

SS7 912ULS

[Av8r3400]

The stainless screw goes in the bottom most hole (6 o'clock). It will act as a drain if you choose. 10 Nm, or 90 inch pounds.

I'm sitting in Rotax training as I type this...

[DesertFox4]

Larry, Thanks for the torque info.:)
I will be using this info tomorrow.
Much appreciated.