View Full Version : 1" overlap requirement
Tomfox
05-03-2015, 04:28 PM
I understood that you needed 1" of overlap on a structural point where it is necessary to overlap the covering material. My SS7 has 1/2" diameter tubing. The maximum overlap I can figure out how to get is 1/4 of a circumference of the circle - or 0.39" Am I misinterpreting the spec?
Thanks
tom
rosslr
05-03-2015, 05:27 PM
Hi Tom,
I assume you are talking about covering with polyfibre? If so, I think they are referring to a 1" overlap of the fabric- not the tube. You attach the fabric to the tube with poly tac and then overlap the fabric over the fabric to achieve the result like in the photo.
Cheers
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.