Tomfox
09-23-2014, 10:48 PM
Two questions -
1. At the root end, the tank sits above the spar because it sits on top of the spar reinforcement fitting. I would need to dremel off about 1/32" about 3/4" out on the flange in order for it to sit down on the spar evenly. Thoughts on this?
2. The manual says to fill in between the tank and the #1 and #3 ribs with flox loaded epoxy. I have about 3/16" gap between the tank and the rib on each side. Is it intended to fill this in without any backing underneath?
Thanks
Tom Livermore
1. At the root end, the tank sits above the spar because it sits on top of the spar reinforcement fitting. I would need to dremel off about 1/32" about 3/4" out on the flange in order for it to sit down on the spar evenly. Thoughts on this?
2. The manual says to fill in between the tank and the #1 and #3 ribs with flox loaded epoxy. I have about 3/16" gap between the tank and the rib on each side. Is it intended to fill this in without any backing underneath?
Thanks
Tom Livermore