View Full Version : Part number for rivets used on flaperon's balancer?
gizmos
03-19-2013, 03:08 PM
Does anyone know what the replacement part number from aircraft spruce for kf5 flaperon mass balance weight rivets? Kf is 3/32 x1/8 Monel p/n 90045-000. Do you use solid rivets on the rear rivets on balancer?
mr bill
03-19-2013, 05:59 PM
It would look nicer if they are solids.
jiott
03-20-2013, 10:03 AM
Why not buy the rivets from Kitfox?
Jim
gizmos
03-20-2013, 11:29 AM
I need the rivet now, aircraft spruce is 30 minutes from me, does make good sense to order, all I ask for was a part number
I don't think ACS carries the 3/32 rivets. I can't find them in the catalogue.
gizmos
03-20-2013, 02:13 PM
Thanks, there is another supplier in sun valley ca that should have them. Just finishing the tips
Geowitz
03-20-2013, 02:14 PM
http://www.aircraftspruce.com/catalog/hapages/solidalumrivets.php
AN426AD-3-2 = 3/32 x 1/8
Order by the pound.
Okay, I thought you were looking for the monel pull rivets.
Geowitz
03-20-2013, 02:26 PM
Oh, sorry, I thought was looking for solid. Well, anyways doing just a few solids are easy enough and finish off better.
Here are some pull rivets...
http://www.aircraftspruce.com/catalog/hapages/cherrynrivet.php
MSP-32 MD319BS = 3/32 x 1/8
There's a flush head version farther down the chart as well, but it's stainless which is certainly usable too.
gizmos
03-22-2013, 11:30 AM
Anyone in Burbank ca area that needs rivets, Hanson rivet 800-777-4838 is the place! Located 13241weidner street pacoima ca 91331
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.