View Full Version : skylight angle/turtle deck spacer
ken nougaret
08-12-2012, 04:46 PM
does anyone know where the spacer #52948.000 can be found for the ss7 kit? it goes on top of the skylight angle(p.45) i looked in the turtle deck box and the windshield box.
thanks, ken
szicree
08-12-2012, 05:07 PM
It was in a box with most of the fuselage stuff, I think. It's covered with white vinyl on both sides so it looks like a strip of aluminum.
ken nougaret
08-13-2012, 08:12 AM
thanks, i found it. it was labled with a different part #11153.401. but the description is correct.
ken
Hi Ken,
I believe that 52948 was an aluminum strip that fit beneath the old aluminum turtledeck. The new part no: 11153 is thicker plastic to go under the preformed plastic turtledeck. Just be sure yours is the plastic one.
ken nougaret
08-16-2012, 12:50 AM
thanks mark, it is plastic.
ken
ken nougaret
08-18-2012, 08:07 PM
the manual says to tape the spacer to the angle. so i assumed the spacer was only temporary. but a few pages later the spacer appears to be permanent. i didn't read anywhere that it said to attach the spacer. does it get bonded to the angle?
ken
Hi Ken,
With the spacer taped in place, match drill it when drilling the wind shield and angle. Then it is held in place with the hardware (no need to bond it). It fills the gap and acts as a stop where the turtle deck slides under the windshield.
ken nougaret
08-20-2012, 08:53 AM
thanks mark!
ken
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.