PDA

View Full Version : uncertainty about 912


HansLab
03-02-2012, 10:49 AM
All,

Need some help - again.. I'm working on the engine now (Rotax 912UL) per the manual, and pic's are a great help. However I can't find any clear pics of the engine in a Classic IV / 912 UL combination (cowl-removed). For example I did not know I had to switchthe manifold units until I found out that the carburettors did not fit between the motormount ;-(

Any pic will certainly help a lot

Tx in advance
hansedj
03-02-2012, 11:50 AM
This is ours in a series 6 had to switch the manifolds.
HighWing
03-02-2012, 12:48 PM
Hans,
Photos below. The scoop and SCAT tubing was for a heater air source. Everything else was pretty standard, I think. Incidentally if you are going to use an oil cooler, tight bends can be made in the oil lines if you insert a spring or coil of wire into the tubing. It will prevent the tube collapsing.
Lowell
HighWing
03-02-2012, 12:52 PM
More Pics.
HansLab
03-03-2012, 10:53 AM
How I just love his forum!!
jdmcbean
03-03-2012, 04:55 PM
May want to leave the carburetors on the appropriate sides and moving only the manifolds.. This will allow for easier adjusting of the throttle linkage and choke.