Dutch
01-20-2012, 12:44 PM
Hi I recently purchased a partially completed kitfox 3 with kitfox 4 1200 mods.
( wings, mixer, etc.) my problem is with the elevator push-pull tube & the flap tube rubbing on the seat bottom the groove in the seat seems neither deep or wide enough. The obvious solution to me would be to modify that portion of the seat. But looking at the various online build logs & postings on this forum I've found no evidence that builders have had to do that. What am I doing wrong?
Also the original builder reamed out the elevator idler bushing to much it has a little bit of slop is there any remedy or do I just need to buy a new one? any help would be appreciated. thanks Dutch
( wings, mixer, etc.) my problem is with the elevator push-pull tube & the flap tube rubbing on the seat bottom the groove in the seat seems neither deep or wide enough. The obvious solution to me would be to modify that portion of the seat. But looking at the various online build logs & postings on this forum I've found no evidence that builders have had to do that. What am I doing wrong?
Also the original builder reamed out the elevator idler bushing to much it has a little bit of slop is there any remedy or do I just need to buy a new one? any help would be appreciated. thanks Dutch