View Full Version : Grommet Product Review
I was recently looking for alternatives to the rubber firewall grommets that came with my kit (KF4). Steve Kellander came across Precision Grommets and sent me an e-mail. They looked good enough to try, so I ordered two of them for my throttle cables. I installed them today and they made for a very stable transition. More on the install here (http://www.azshowersolutions.com/Engine13.html).
Iceflyer
06-30-2010, 05:27 AM
Nice
This "E-brake" you have? What´s that. Electric parking brake or what
I called it an E-Brake...I guess best called a Parking Brake. I have the Grove Parking Brake attached to a cable and a spring. The knob has a lock on it.
1251
1252
Iceflyer
06-30-2010, 09:11 AM
Ok, I like that. Better than having to run after the airplane when it starts rolling down the ramp like I did the other day
Thought I'd share one more item I just installed from Precision Grommets.
The picture is of a grommet made of Nylatron. I called and asked for a non-conductive grommet that could stand up to heat (for my #4 starter cable).
I'm told it will be good to 300 degrees.
1564
1565
1566
cap01
10-20-2010, 07:59 PM
rather than using a gromet and trying to bend the heavy starter wire around to get it thru the fire wall , i used a feed thru stud that worked really well . never any worries about chafing .
Chuck, Those look like a nice option. Thanks for the post!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.