View Full Version : Trim sensor install instructions
tdldedcd
05-01-2021, 02:24 PM
Hi All,
Looking for a little help. I got out the instructions for the trim sensor install to go over them, but it looks like they have gotten inadvertently thrown away. Does anyone else have a copy of these they would be able to share.
Thanks for you help.
Todd
Eric Page
05-02-2021, 05:06 PM
This is the instruction sheet that came with mine, ordered about six months ago.
27971
tdldedcd
05-03-2021, 06:52 AM
That's perfect. Thanks Eric
MikeFairbanks
02-19-2024, 02:25 PM
I was hoping someone can confirm what's on each wire...
Eric's attachment shows...
Blu/Wht = Pin 1
Org/Wht = Pin 3
White = sweeper
I'm assuming that translates to...
Blue/Wht = 5V
Org/Wht = Gnd
White = position
I just haven't been able to confirm this anywhere. Thanks
Eric Page
02-19-2024, 11:35 PM
Yeah, the factory instructions are pretty terrible but that's how I read it too.
MikeFairbanks
02-20-2024, 08:40 AM
Thanks Eric, I went ahead and hooked it up like that and it is working fine.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.