Stainless door frame cap

[N14ND]

Those of you who put the stainless steel or aluminum lower door frame scuff cap on, what adhesive did you use? The structural adhesive or ?? I have been thinking about using Proseal or 3M 5200 as they are more flexible. I bent up some ss caps and have them in place, but not adhered yet.
Thanks.

[desertdave]

I used 3 pop rivets per side. If you ever need to remove them you are out of luck if you glued them.

[N14ND]

Hmm. Not big fan of drilling holes in steel fuselage tubing, but it would hold it in place.

[efwd]

I used a small amount of silicone caulk. Its attached and when I recover the airframe it will rip right off.

[jiott]

I used a small amount of Hysol. I think if I ever need to replace them they will pull off, but will probably need new sill protectors.

[jrevens]

I used silicone sealant also.

[PapuaPilot]

I bent my own door sill angles out of aluminum and used silicon.