PDA

View Full Version : IO 240 spinner.



Ronnybaize
02-01-2020, 10:14 PM
I want to put a nicer spinner on Kitfox 5 IO 240 than a bolt on divers helmet. Using a sinsenich prop order spinner And the backing plate hits cowling John at kit fox says they don’t make and inverted backing plate. Don’t want to cut my cowling out. Does anyone had this problem? Ideas?

jrevens
02-03-2020, 01:48 PM
You could put a spacer plate between the engine's prop hub and the spinner rear plate (bulkhead)/prop.

Ronnybaize
02-12-2020, 09:47 PM
My have found company in Wisconsin to fix new inverted backing plate for spinner. If not will build a spacer place to off set depth of backing pale. Thanks for reply