Continental Engine Mount Instructions

[N14ND]

Series V Outback
Looking for the instructions for mounting the Continental engine mount, hardware call-outs, torques, etc. I can't seem to find the engine section of my builders manual (probably stored in a "special" place). I am ready to hang the 0-200 on the airframe. Also, I need the section on mounting the engine to the mount. I have the instructions that are in the "official" Continental Engine Manual, but wanted to see the way Skystar/Kitfox mounts the engine. I have a box of hardware that I have collected that are labeled "engine", so I hope I have all the correct parts.
Thanks!!

[ken nougaret]

Is this what your looking for?

[N14ND]

That is it!!
Don't want to assume anything, but I would "assume" that the drilled out AN3 washer is on the engine side of the stainless steel firewall.

[jmodguy]

Your assumption would be correct!

[N14ND]

Thanks y'all!

[N14ND]

Another question: Just wanting to confirm that is “no” washer under the head of the bolt on the engine mount-2-fuselage attachment.

[PapuaPilot]

That is correct, I didn't use any. Installing washers wouldn't be a problem if the bolts are long enough, but they are not needed.

[francisco j Ocampo]

24807I have a vixen nose gear with contiental o200, please, could someone help me with some pictures of the motor mount at the bottom, I had an accident and I should see how it was installed
my email. fjo2006@gmail.com
thanks



https://teamkitfox.com/Forums/image/png;base64,iVBORw0KGgoAAAANSUhEUgAAABQAAAAUCAQAAAA ngNWGAAAA/0lEQVR4AYXNMSiEcRyA4cfmGHQbCZIipkuxnJgMStlMNmeyD2d wmc8 sZgxYJd9ErIZFHUyYYD7fkr6l4/rnvmtl7 KitrqV/fq2Y5eLY3Z9S48eRLe7BmVZ9qhTLhQ0algzZWQOVKSsCF8OjAn wbxDTWFDUhPK/jMr1H6HE/IqRky2DyvCefuwItwZzodVoYRiLqMkVCXrwpJ9twZ sgfDYEFYl8wIWxZ9uFf7zkallxlJh4YrLGsKjZRx7VGHhLqwgF UN45DGdb8MeXGpgB4ABZdeDcpZEY51A hyLKz4S1W4MQWm3AibWtgWmk6dyISa1pSdyWTOlLXVp0 eL9D/ZPfBTNanAAAAAElFTkSuQmCC