Register
Help
Remember Me?
What's New?
Activity Stream
New Group Messages
New Events
Mark Forums Read
Forum
Advanced Search
Home
Activity Stream
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
Groups
Groups
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
Today,
09:40 AM
VictorV
started a thread
Airtech Coatings
in
Kitfox general discussion
Has anyone painted their KF with Airtech? What are your thoughts on this? Considering AT vs PPG since PPG is so...
see more
0 replies | 3 view(s)
Today,
09:19 AM
hagant
started a thread
FS: Rotax 912is, Airmaster 3-blade Prop, FWF package for Kitfox series 7
in
Classifieds
$27000. Looking to sell as a complete package. 320 hours on engine and propeller. Located in Utah, UT9...
see more
0 replies | 4 view(s)
Today,
01:43 AM
Birdseyeview
started a thread
oil Soaked lower spark plugs
in
Engines
My 912ULS is an older engine but only has 95 hours run time total. It has run strong and never consumes any oil. It...
see more
0 replies | 22 view(s)
Yesterday,
11:59 PM
Auster
replied to a thread
Pitch Trim problems S5
in
Kitfox general discussion
Jim, my access hole is not really in line with the bolt but at least I can see the nut and should be able to get a...
see more
8 replies | 191 view(s)
Yesterday,
10:11 PM
jiott
replied to a thread
Pitch Trim problems S5
in
Kitfox general discussion
I put one of those round access hole rings in the fabric in line with that trim servo lower bolt. I haven't yet, but...
see more
8 replies | 191 view(s)
Yesterday,
04:44 PM
Navycposd
replied to a thread
Pitch Trim problems S5
in
Kitfox general discussion
Buy a digital endoscope on Amazon ... a few mm in diameter, lighted and a camera on the subject! I needed it to get...
see more
8 replies | 191 view(s)
Yesterday,
11:37 AM
alexM
replied to a thread
Pitch Trim problems S5
in
Kitfox general discussion
I practiced reaching that lower bolt several times before I covered my fuselage, and I did my final installation with...
see more
8 replies | 191 view(s)
Yesterday,
08:53 AM
PapuaPilot
replied to a thread
912 ULS Oil Pressure Sender
in
Engines
That is the most typical failure. Next is broken, chaffed or grounded wiring.
see more
8 replies | 270 view(s)
06-22-2025,
08:28 PM
jiott
replied to a thread
912 ULS Oil Pressure Sender
in
Engines
Mine got quite erratic when it (VDO) failed. I suppose their are other failure modes.
see more
8 replies | 270 view(s)
06-22-2025,
08:14 PM
Av8r3400
replied to a thread
EAA Airventure 2025
in
Kitfox general discussion
We gave up on the Stadtmueller family last year and went to Scholler. I'm not into their family drama any more. This...
see more
6 replies | 1214 view(s)
06-22-2025,
05:49 PM
Robthend
replied to a thread
Wing storage
in
Kitfox general discussion
I use various, padded storage hooks to hang wings from my garage ceiling. Also did similar to hang tail feathers and...
see more
6 replies | 373 view(s)
06-22-2025,
02:15 PM
bumsteer
replied to a thread
EAA Airventure 2025
in
Kitfox general discussion
With 4 weeks til opening day, the 5th work weekend just completed. Although the heat was brutal (+100 heat index) it...
see more
6 replies | 1214 view(s)
06-22-2025,
07:45 AM
Auster
replied to a thread
Pitch Trim problems S5
in
Kitfox general discussion
Today I dismantled and cleaned the switch, the contacts were very dirty and could easily have been the problem. However...
see more
8 replies | 191 view(s)
06-21-2025,
06:14 PM
Shadowrider
replied to a thread
912 ULS Oil Pressure Sender
in
Engines
Okay good to know! What are the symptoms of when they fail? Just read nothing?
see more
8 replies | 270 view(s)
06-21-2025,
06:11 PM
Shadowrider
replied to a thread
One Lucky Fox
in
Members' Build Logs
Tell us more?! With the header tank that shouldn?t happen? What did your data log look like?
see more
128 replies | 149923 view(s)
06-21-2025,
11:41 AM
Auster
replied to a thread
Pitch Trim problems S5
in
Kitfox general discussion
Eric thank you that is very comprehensive and helpful. If I establish that the switch and wiring are not the problem...
see more
8 replies | 191 view(s)
06-21-2025,
09:33 AM
Eric Page
replied to a thread
Pitch Trim problems S5
in
Kitfox general discussion
This is a long shot, but the trim actuators in the S5 used brushed motors (maybe they still do; I don't know). It...
see more
8 replies | 191 view(s)
06-21-2025,
08:24 AM
atosrider
replied to a thread
Summer brings high coolant temps - Model 4 Speedster, 912UL
in
Engines
the theory of air flow is the exit must be larger area than the inlet, creating a lower pressure zone and encouraging...
see more
1 replies | 93 view(s)
06-21-2025,
06:24 AM
PapuaPilot
replied to a thread
Pitch Trim problems S5
in
Kitfox general discussion
Sounds like you are checking everything properly. I had a bad rocker switch and had to replace it.
see more
8 replies | 191 view(s)
06-21-2025,
12:28 AM
Auster
started a thread
Pitch Trim problems S5
in
Kitfox general discussion
It's a standard electric pitch trim on an S5 with just over 600 hours. On several occasion recently, in flight, the...
see more
8 replies | 191 view(s)
06-20-2025,
06:20 PM
JackScott
started a thread
Summer brings high coolant temps - Model 4 Speedster, 912UL
in
Engines
I have a Model 4 Speedster with an older 912UL engine. I?m seeing high CHT during full power climbs, with temperature...
see more
1 replies | 93 view(s)
06-20-2025,
11:35 AM
jiott
replied to a thread
912 ULS Oil Pressure Sender
in
Engines
Kitfox sells a nice remote mount kit, which is what I am using.
see more
8 replies | 270 view(s)
06-20-2025,
11:33 AM
jiott
replied to a thread
912 ULS Oil Pressure Sender
in
Engines
Dustin, I have had one VDO sender fail after about 800 hours. It was remote mounted on the firewall. I replaced it with...
see more
8 replies | 270 view(s)
06-20-2025,
10:49 AM
Shadowrider
replied to a thread
912 ULS Oil Pressure Sender
in
Engines
Jim have you had one fail? Is there a history of them failing?
see more
8 replies | 270 view(s)
06-19-2025,
07:11 PM
jiott
replied to a thread
912 ULS Oil Pressure Sender
in
Engines
I would highly recommend a remote mount for longevity.
see more
8 replies | 270 view(s)
06-19-2025,
12:22 PM
airlina
replied to a thread
912 ULS Oil Pressure Sender
in
Engines
Can't speak for a rotax , but I had several failures of engine mounted senders on my Continental . Finally went remote...
see more
8 replies | 270 view(s)
06-19-2025,
11:35 AM
yocum137
replied to a thread
One Lucky Fox
in
Members' Build Logs
😂🤣😂🤣 Speaking of high angle of attacks, during my light weight, forward CG tests, I had about 7 gal - 3.5 gal each...
see more
128 replies | 149923 view(s)
06-19-2025,
11:03 AM
Kitfox Pilot
replied to a thread
One Lucky Fox
in
Members' Build Logs
I'll have to check that out. I can get below 20 when I'm headed straight up and doing a hammer head turn. Haha
see more
128 replies | 149923 view(s)
06-19-2025,
10:48 AM
yocum137
replied to a thread
One Lucky Fox
in
Members' Build Logs
I should qualify my statement - when I analyze the garmin logs the ASI bottoms out at 32, before I recover. When...
see more
128 replies | 149923 view(s)
06-19-2025,
09:26 AM
Kitfox Pilot
replied to a thread
One Lucky Fox
in
Members' Build Logs
You are way under my stall speeds. 38ish with power and 43mph no power stall. You are doing good!
see more
128 replies | 149923 view(s)
More Activity
No More Results
No Recent Activity