Activity Stream

One negative is that it's a 1050 gross weight. But it does look like a nice plane, and I'm sure it performs nice. I...

Thanks Brett. I am very fortunate when it comes to the shop and after reading some of the horror stories about the...

Any opinions?

Found one thanks to a member via PM. THANK YOU -Jeff

Some details on the wingtip light mount for Jason. It was a real pita getting it all to work. Third pic is upside down....

Looks good Gary. I remember all the gyrations it took to coax my mounts in. Beautiful shop by the way! That 22000uf...

Thanks for posting that Jason, I ordered some 3/16 NSR nylon tubing from a/c Spruce and might redo some of the high...

It is a totally different kit but Vans will run the 3003 versatube all the way down the gear leg loop it around the...

Haha, Ground speed got to 6mph backwards.

Hi Mike, do you only have parts for a kitfox 4 or are parting out a kf4?

So you were going 46mph backwards? Nice!

Hey Ralph, just curious. What version and date is your page of the manual? For that page, Final Assembly, Section A,...

Thanks for all the replies. Since some of you did have 1/2" tubing I'm not crazy! I'm using the 1/2" since it's...

Synchronizing has to be done with the carbs installed on the engine and running. However, at or near wide open...

In the heavy maintenance manual there is a resistance value for the plug caps. I'd suggest checking these before...

Thanks, I plan to examine the plugs tomorrow

Hi John, the new coils came with new wires already attached, but thanks for the suggestion

Hi Umberto - the answer is no, I suppose I assumed that the factory looked at that when I sent them back, but i could...

Check leads where they attach to plug cap if that centre screw isn’t correctly installed may be your issue hard too....

Ignition wires?

Stupid question: did you go through a proper carburettors synchronisation? Inviato dal mio iPhone utilizzando...

Installed aluminum strips on left wing tip. Used dremel to remove excess Hysol from wing rib. This increased edge...

We took delivery of our SS7 kit in October 2021, supplied tubing was 1/2" as called out in the plans.

EPISODE 6 - RIBS & VARNISHING + BLOOPERS

EPISODE 5 - HORIZONTAL SLIDER BLOCKS

If you built your wings, you used that 3/8" tube for stringers and should have 4 pieces long enough for the job. I...