Activity Stream

On the 912ul I had one 90 degree bend. Gates 19489 ...

Thanks for that contact ,I will email them this morning

I have been using the Proto JFP210M Differential Pressure tester. Amazon has it in stock:...

Great! I will give that a try John. Maybe this is the project that I break down and buy a Lincoln Electric welder. I...

If worse comes to worst you can make your own. I’ve done it a couple of times. Take an old plug and “gut” it ......

In my previous pic I mention possibly knowing where your shipments are. Ships in the harbor. I think all the...

http://www.algiecompositeaircraft.com/blog/8-385mph-on-14-5gph Dave Algie built the LP-1 here in Indy. His financial...

regarding the foam on the flapperon, I tapered mine back where the relief just met the trailing edge of the aluminum. I...

I saw the molded seat units your working on. Boy is that downright butchery:eek: It looks like you have the right...

Check your PMs

Looks good. Yeah the original builder probably did everyone a favor by passing on that plane to someone who actually...

Today I started by sanding out the three spots of SuperFil that I added to one flaperon yesterday. One of them still...

I'm now booked to fly at Stick and Rudder on March 21,22. I'll be flying a standard wing plane powered by a 912iS big...

Planning to be there this year working the South40 aircraft parking. Honestly, I have a feeling it will be empty as it...

I recently experienced a ground-loop. I am now in the other group of those that have. . . in the end, I nosed over and...

Ifly, your doing good. If you can hold the tool in the vice. Make sure you real tighten the bolts while you bottom...

That would be very much appreciated

That's great, David. Those type have been around forever (I have one myself). What you did looks very nice, and the...

I'm very happy with the IvoProp setup and props can be one of the most difficult decisions to make. Good comparative...

Brian makes some great points that I agree with. One thing I like about the Edge engines is the ability to tune the...

I'm on the list for a kit. really well thought out.

No more like this one : https://www.aircraftspruce.com/catalog/topages/swagingtool.php?clickkey=6674 Sent...

It's hard to see in the photo (borrowed from ACS) ifly, Is this the crimper you have ?

Then you are fine. Looks good. Don't forget to put a piece of heat shrink tubing on the cable before swaging the end.

Dusty, I live close to where they are built. Let me check around as there are lots of them in the area and a few...

Ken, this is a battery box. It’s for the Earth X battery which is really light. It’s not all the way back in the tail...

I have a 914 that was built by Edge. I added the injection kit after about 100 hours on the carbs. It idles much...

Thomas makes top notch products. The EP912STI pulls hard and performs great. Of course turbos are not for everyone....

It’s 3/32 cable that was included with my 7. Sent from my iPhone using Tapatalk Pro