Activity Stream

Outstanding. Great idea, Brett. Did you bond the alodined clamp to the push tube to avoid potential slippage?

Woo hoo! Looking fantastic, Alex. Can't wait to see it fly!

I'm probably going to do something very similar to what Brett shows in his post above. I have it mocked up right now...

Hey Chris, Here's how I attached the servo arm to the elevator pushrod. I made an aluminum bracket in such a...

A lot more hours in the past couple of weeks. To the untrained eye the plane looks pretty much the same as last month ...

I'm not impressed with Rotax delivering this $$$$$ flagship engine with such a glaring basic flaw in the metallurgy. ...

There is a Ridgerunner Skyraider group on Facebook Someone there can probably help you.

Well, the 916 is down for the hopefully last Service Bulletin....... The gearbox is headed in for a new case after...

Eric, old post, I know. However, I'm just getting to this step with my own Series 5. Thanks for the photos of your...

Bumping my own thread, anybody have any info on Rocky Mountain Wing landing gear?

Brett, Thanks for sharing. Those morning shots with fog in the valley are precious!

Woke up early for the Dawn Patrol a few days ago! Flew from Bolivar to Lebanon, Mo. just because I could. Beautiful...

I recently discovered these when fabricating a modification to my car (coolant vent line). The "tool" looks...

Now THAT is a minimalist instrument panel!

A big box arrived from Grand Rapids. I have started trying to place the 10.1 EFIS and the servos for pitch and roll. ...

Another option is Oetiker clamps (also known as ear clamps). They're a single-use clamp that requires a special tool,...

I had the same problem. When I replaced the hoses, I used constant tension clamps from Belmetric....

Thanks Dave. I found them now. About $12.50 each currently. JImChuk

Jim, If you know me, I wouldn't pay 100 for a clamp! I'm too cheap! The ones I got were part # 0427735 for a box...

I tried to find those fastenall clamps, are they about $100 each? or was I looking at something else? The link you...

Brad, I believe what works best for the rotax coolant hoses is constant pressure clamps. The Rotax constant pressure...

The Tarriffs are absolutely happening.. currently 10% base, and you are correct, Rotax really cannot do anything about...

I?m working over the Bing carbs on my HKS700. They had car gas in them. These Bings look nearly new, less than 100...

Sorry it took so long to respond. I couldnt get on the website for some reason. Anyway thank you all for the welcomes....

Got it. Thanks Phil