Does anyone have any hints on how you held the jury strut clamps in place when you installed the lift strut fairings? I haven't been able to find much on the forumn.
Thanks,
Bob
Does anyone have any hints on how you held the jury strut clamps in place when you installed the lift strut fairings? I haven't been able to find much on the forumn.
Thanks,
Bob
I carefully measured the location and cut a square hole in the fairing just large enough to fit over the compressed clamp ends. Then used safety wire to hold the clamps closed tightly in place on the struts and installed the fairing over the clamp ends. Sealed the gaps around the clamps with superfill to keep water out.
Tom Jones
Classic 4 builder