What are these tabs for? I started to use them for a ground location but I thought I should ask first.
IMG_2272.jpg
What are these tabs behind the baggage area for?
IMG_22685.jpg
And finally, where is the drawing V29 in the manual?
IMG_2271.jpg
What are these tabs for? I started to use them for a ground location but I thought I should ask first.
IMG_2272.jpg
What are these tabs behind the baggage area for?
IMG_22685.jpg
And finally, where is the drawing V29 in the manual?
IMG_2271.jpg
The tabs in the baggage area are if you want to extend your baggage area you have tabs there to drill into.
V29 should be in there very first chapter of the manual under builder tips I think....
I used the one behind the firewall to attach a support tube to the upper edge of the instrument panel near center. I am pretty sure the kit came with the support tube.
Maxwell Duke
Kitfox S6 IO-240 Built it (Flying since 2003)
Maule M7-235C Sold it (liked it though)
RV-10 IO-540 Bought it
Zenith CH-750 Built with 7 friends (DAR Vic Syracuse)
Thanks guys. I guess I will blank off the heater ports and save them just in case I install a heater later.
"And finally, where is the drawing V29 in the manual?"
Section G Figure G-1 would be correct.. not V29.
Thanks. I recently received an updated build manual that I keep at home for night reading. Low and behold, the page was there. I will be able to finish up the rigging tonight.