Kitfox Aircraft Stick and Rudder Stein Air Grove Aircraft TCW Technologies Dynon Avionics AeroLED MGL Avionics Leading Edge Airfoils Desser EarthX Batteries Garmin G3X Touch
Results 1 to 9 of 9

Thread: Inspection rings and drain grommets

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1

    Default Inspection rings and drain grommets

    Hello Team K
    I’m placing an order for some supplied at Kitfox and thought I would go ahead and get more inspection rings and covers, only four come with a kit. Also need to get some of the plastic drain grommets. My question is how many should I get of each?
    I was unsuccessful doing a search for this but somewhere in the archives is a layout for under the wing inspection/access covers. Some help finding this would be nice.
    My build is coming along well
    Joe Gallagher
    Flying 7SS

    http://frontierfox.home.blog

  2. #2
    Senior Member efwd's Avatar
    Join Date
    Jun 2015
    Location
    Yorba Linda, CA
    Posts
    2,830

    Default Re: Inspection rings and drain grommets

    I have only two on my plane. one each wing so I can inspect the strut attachments. Some people put one on the bottom to inspect the pitch bell crank in the fuselage. Im small enough to make a crawl back there. Some people put one near the tail wheel attachment. The nice thing about Oratex fabric is that I can add inspection holes any time I like.
    Eddie Forward
    Flying
    SS7, 912iS, Garmin G3X

  3. #3
    Senior Member rv9ralph's Avatar
    Join Date
    Aug 2014
    Location
    Greenleaf, ID
    Posts
    620

    Default Re: Inspection rings and drain grommets

    Another good place for an inspection ring is near the pitot tube in the wing. Also, if you mount any remote items (magnetometer or antenna) in the wing, you may also need access there later.

    Ralph

  4. #4

    Default Re: Inspection rings and drain grommets

    It is easy to get a cheap borescope and look at and take pictures of any area of the aircraft without cutting into the fabric. Check out Amazon. The inspection rings should be where you will need access for maintenance, like lubrication.

  5. #5

    Join Date
    Sep 2015
    Location
    Crawford, CO
    Posts
    165

    Default Re: Inspection rings and drain grommets

    That is true until you need to fix/replace something. Then you're cutting fabric. I'd rather have the inspection ring so I can get to the item if need be.

  6. #6
    Senior Member
    Join Date
    Jun 2008
    Location
    wales,ny
    Posts
    715

    Default Re: Inspection rings and drain grommets

    Flew this morning and counted my inspection rings: 6 in the wings -three each side- 1 inboard below fuel tank plumbing, 1 mid by jury strut attach, 1 outboard by pitot tube/ and lift strut attach points. 6 in Fuselage- 1 below cabin , 2 below elevator torque tube bearing (to get hands in for greasing) 1 across from the 2 I just described that I recently cut out and used for my ADSB antenna, 1 on the right aft side that I used for jackscrew inspection,1 further aft to access tailwheel hardware. remember more is better when placing rings during cover, if you never cut them out no big deal, but if you need access and no ring is there, you will be kicking yourself. Bruce N199CL

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •