I'm sure this has been discussed before but I couldn't find an answer.
What do I do with the big gap between the window frames and the door frames?
Book says to rivet at those points.
I'm sure this has been discussed before but I couldn't find an answer.
What do I do with the big gap between the window frames and the door frames?
Book says to rivet at those points.
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
Isn't there a Kitfox factory video about this? I know I have seen it. I have been looking for it with no luck.
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
DesertFox4
Admin.
7 Super Sport912 ULS Tri-gear
Thanks Steve. I'm still wondering what to do with the big gap. I see John had a big gap too. Do I bend it over and rivet or fill it?? Does the fabric attach to these frame pieces? thanks
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
Harlan, I bent the outer one over and riveted them together. Then I superfil'd over them and it turned out great.
S7 STi O-320 currently flying
Make sure you have the pieces oriented properly. My first pass I had a couple of them in the wrong place. That made the gap bigger. I still had a gap in the end though. Tweak them a bit, hysol and rivet. Then superfill. A window needs to go inside and attach so they should be on the same plane to accommodate that. Fabric goes over all sides of it too.
Flying SS7, G3X, 912iS
https://mountainfoxbuild.wordpress.com/
Thanks guys!
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos