I’ve been working on the fibreglass tail fairing.
So I’ve got it installed, and it’s flush at each rib location, however it bows out slightly between each rib.
I’m wondering if anyone else has had this — and if there is a solution, or if the fabric will pull that bow down?
I kinda guessed at the location of the fairing when installing it. I couldn’t find any registration marks on it like on the rudder. Prior to installing the ribs I tested both the bottom and top rib in the fairing and marked where they “best fit.” This seemed pretty good when cutting the holes and slot… most of the excess fairing was at the bottom, only about 2” over hang at the top. Obviously if I did it again I’d move the fairing down even more… but it’s a bit late for that now…
Any help would be greatly appreciated.
Dave.
Sent from my iPhone using Tapatalk