Got the seat pan in. I'm curious if you guys trim the edge of the seat Pan with the square tubing of the fuselage mine sticks up about a quarter to an 1/8 of an inch in some places thanks.
Sent from my SM-G960U using Tapatalk
Got the seat pan in. I'm curious if you guys trim the edge of the seat Pan with the square tubing of the fuselage mine sticks up about a quarter to an 1/8 of an inch in some places thanks.
Sent from my SM-G960U using Tapatalk
I did but make sure you trim and fit everywhere else prior to trimming the edges. You want to make sure the seat pan in fully seated down where it is “comfortable” and then trim the sides.
Sent from my iPhone using Tapatalk
Ben Bell
Building 7 super sport
O200 powered
I did its sitting on the mounting tabs now.
Sent from my SM-G960U using Tapatalk
Yes, trim it flush with the square tubing, or just a hair lower. You don't want to be catching that thin edge sticking up as you slide your butt in and out over the square tube.
You will be wrapping a single layer of upholstery fabric over that thin edge, so trim it a scotch (hair) low to begin with.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS